SL60 Hand Torch and 20 foot / 6.1 m Leads, with ATC Connector

7-5204

The 1TorchTM SL60 and SL100 Torches work with most plasma cutting power supplies. The Torches are equipped with either O2B connectors or the Thermal Dynamics ATC connector and are connected using various Adapter Kits sold separately. A label on the torch handle indicates the torch model number. SL60 Torches provide cutting capabilities of up to 60 amperes. SL100 Torches provide cutting capabilities of up to 100 amperes.

The torches use compressed air as both the plasma and secondary gas. The torches are suitable for drag cutting (with the torch tip in contact with the workpiece, at up to 40 Amps output); 40-100 Amp shielded drag cutting (with shielded torch parts (cap, etc.) in contact with the workpiece); standoff cutting; or gouging. Refer to the Complete Assembly Replacement page for configurations and catalog numbers. These instructions are important for the proper installation of the Torches.

Read the instructions thoroughly before attempting the installation. Keep these instructions for reference. Supplied Parts The Replacement Torches include: Torch With Leads - 1 each Installation Instructions - 1 each Consumables (Installed on the Torch): Electrode, Starter Cartridge, Tip, Shield Cup Body and Drag Shield cap .